Installing a Brick Paver Walkway or Brick Crusher Machine

The use of Bricks or Pavers to create a sidewalk or outdoor patio complements a home in a method that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily need a pro.

The secret to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be set up. The area should be dug out at least a foot down, removing all topsoil and clay soil. In addition, string lines should be strung on each side of the sidewalk. The string lines suggest the completed height of the walkway.
Once the location has been dug, 3/4" gravel stone must be laid in and tamped down tightly. 2" of sand, or stone dust need to be spread out over the gravel. Again the sand/stone dust need to be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline ought to equate to the thickness of the brick or paver.

Now that you have a stable base, position a 1" pipe or journal board the length of the walkway on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up an operate on both sides of the ready area. These strips will serve as your sidewalk border and assistance to keep the stability and shape of the walkway. You can get these plastic strip borders at most home improvement stores. The strips must be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the pathway.

Undoubtedly bricks/pavers will require to be cut or split when building the sidewalk. To really cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. If your walkway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outdoors edges with extra sand, and then shovel in the topsoil and load down strongly.
Spread stone check here dust over the brand-new pathway and sweep into the cracks. Repeat this procedure a couple of times to ensure the fractures are fully filled. This will finish the interlocking of the bricks and help to remove any weed development. Just include turf seed to the outdoors edges and you must have a gorgeous entryway to your home within a number of weeks.


In addition, setting up a Brick or Paver pathway does not always require a pro. The secret to installing a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipe or ledger board the length of the sidewalk on either side of the walkway. These strips will act as your sidewalk border and help to preserve the stability and shape of the sidewalk. Inevitably bricks/pavers will need to be cut or divided when developing the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Installing a Brick Paver Walkway or Brick Crusher Machine”

Leave a Reply

Gravatar